Wall Mount Installation of Terra Prime (Compact), Terra (Compact), Strato V, Strato C, and Strato M

Before assembling, use the mount plate to mark your drill locations. Mount to wooden studs when possible, otherwise, use the wall anchors provided (3/16” drill size). Zip tie mount to a Versaplate.

1. Place the Strato player or compact Terra server upside down on a soft and clean surface.

2. Use the included size #1 Philips screwdriver to remove the two frontmost side screws from the bottom. Strato M does not have these.

   
   Strato V & Strato C
   
   
   Terra Prime (compact) and Terra (compact)
   
   

   Strato M
   
   

3. Using the provided M2.6x8mm screws, fasten the mount plate as shown below. Be careful not to strip the screw heads by overtightening. Strato M uses the inside set of mounting holes. The other units use the outside set.

    

   
   Strato V & Strato C
   
   
    
   Terra Prime (compact) and Terra (compact)
   
   
   Strato M
   
   

4. Firmly mount to the wall using the #6 screws included in the kit. Mount in a recommended orientation (see below). 

Recommended Orientations 

Point the front panel to the ground for best cooling. Pointing the front panel to the left, right, or an angle in between is also supported.

*Front panel pointing to the ceiling, or angled upward, is not recommended because the unit will run hotter.

**Do not mount upside down on a ceiling or overhang.

Supported mount orientations (and angles in between):