Wall Mount Installation of Terra Prime (Compact), Terra (Compact), Strato V and Strato C

Before assembling, use the mount plate to mark your drill locations. Mount to wooden studs when possible, otherwise, use the wall anchors provided (3/16” drill size). Zip tie mount to a Versaplate.
 

1. Place the Strato or compact Terra upside down on a soft and clean surface.

2. Use the size #1 Philips screwdriver, included in the kit, to remove the two frontmost side screws from the bottom. Keep these for later. 
   
    

Strato V & Strato C

 

Terra Prime (compact) and Terra (compact) 

 

3. Fasten the mount plate as shown below. Be careful not to strip the screw heads by overtightening. 
   
    

Strato V & Strato C


 

Terra Prime (compact) and Terra (compact) 
 

4. Firmly mount to the wall using the #6 screws included in the kit. Mount in a recommended orientation (see backside). 

Recommended Orientations 

Point the front panel to the ground for best cooling. Pointing the front panel to the left, right, or an angle in between is also supported.

*Front panel pointing to the ceiling, or angled upward, is not recommended because the unit will run hotter.

**Do not mount upside down on a ceiling or overhang.



Supported mount orientations (and angles in between):